Industry news

Application of central joint Rotary Seal under high pressure

Views : 237
Author : Toparts
Update time : 2019-09-03 16:08:26

Double-acting Turcon Roto Glyd Ring V seals accommodate high PV (pressure: velocity) value, allowing machines to run at high speed with high fluid pressure for extended service life. Reduced contact surfaces under all operating conditions significantly reduce friction and wear characteristics without compromising sealing performance. The seal also gives improved performance in oscillating conditions or where frequent changes in pressure and velocity occur. It runs with low frictional torque at all pressures from 0.5 MPa and above with low sensitivity to pressure increases from 0.5 to 20 MPa. An elastomer ring installed in the lubricating groove prevents static leakage through the ports. When pressurized from one or the other side, the elastomer ring opens the port on the pressure side and equalizes the pressure beneath the elastomer ring—pressure-balancing the seal by more than half. Shifting pressurization through the ports also improves lubrication under the seal.Center joint seal kit

Related News
Read More >>
What happens when the hydraulic cylinder works malfunction? What happens when the hydraulic cylinder works malfunction?
May .29.2020
It can happen at anytime, most often without notice — your cylinder has failed. More often than not the failure can be attributed to a seal or seals used inside of the cylinder. Let’s take a look at the types of seals typically found inside a hydraulic
thermometer wholesale,infrared thermometer,digital thermometer,forehead thermometer thermometer wholesale,infrared thermometer,digital thermometer,forehead thermometer
Mar .22.2020
Thermometer Infrared Measure fever infrared Digital Thermometer for body Forehead Measurement Non-Contact IR Termometro
What should I do if the hydraulic cylinder of the excavator leaks oil? See here to know! What should I do if the hydraulic cylinder of the excavator leaks oil? See here to know!
Nov .13.2019
I believe that everyone must have encountered the oil leakage of the hydraulic cylinder. For the excavator, once the hydraulic cylinder leaks, there will be a phenomenon of slow lifting and insufficient digging force. Let's start this discussion with this